Аксессуары/запасные части для системы протягивания кабеля

For tensioning both bare and covered conductors' overhead line spans. The grips cover a wide range of diameters and make a good fixing and high tension force. CT102.1201 is easy to install and change on the line.

For tensioning overhead line spans of four core cables. The grips cover a wide range of diameters and can supply high-tension force.

For tensioning overhead line spans of single wires.

For tensioning overhead line spans of four core cables. The grips cover a wide range of diameters and can supply high-tension force.

For tensioning both bare and covered conductors overhead line spans. The grips cover a wide range of diameters and make a good fixing and high tension force. CT102 is easy to install and change on the line.

The stringing wheel is fixed on the neck of the insulator, so that the wheel is on the side of pulling direction. The type ST 168.2 is equipped with an upper sheave which keeps the pulling wire and conductor on the wheel also on uneven ground.

Swivels are essential for effective pulling operation of underground cables and overhead conductors. The swivels are fitted with bearings to prevent build up of twist and loops in the cable or pulling rope.

This additional roller set fits easily onto the SO99 clamp. It is used when angles exceed 30 degrees.

Cable pulling through wheel for underground cables.

For tensioning overhead line spans of single wires.

For tensioning overhead line spans of single wires.

Tightening tool for pole reinforcer.

Stringing wheel with two sheaves for angle poles. Sheaves are made of nylon and frame of galvanized steel. The frame solution of stringing wheel makes it possible to pull cable around corners. Chain attachment is simple and quick. In placing the sheaves, the necessary dimensions are to be taken into account when moving the cable to clamp. Distance between the shafts of sheaves is 200 mm. Breaking load is 6 kN in direction of the pole and 24 kN vertically to pole.

Stringing wheel ST26.11 is for straight line sections and inside line angles. Sheaf is made of nylon and frame of galvanized steel. By using chain attachment, the wheel can be hung at desired height and cable can be pulled out. Breaking load is 8.4 kN in direction of pole and 14.6 kN vertically to pole.

Stringing wheel for straight line sections. Sheave is made of aluminium alloy and frame of galvanized steel. In dimensioning the frame, the conductor attachment beside the clamp has been taken into account. The wheel hooks are dimensioned so that they are suitable for hanging on RKKP and RKKUH hooks.

Steel tube frame is fixed on a steel plate. Because of the base plate, the centre of gravity is low. The base plate is furnished with holes and so it is easy to fasten with nails to boards etc. The frame is painted. The rolls are of aluminium alloy and equipped with sealed ball bearings.

For tensioning overhead line spans of four core cables. The grips cover a wide range of diameters and can supply high-tension force.

Is used for stringing the conductor on porcelain insulators.

Sahlins 6822-0000